- Prop up forward wheels противооткатными boots, поддомкратьте a back of the car and establish it on props. Remove back wheels.
- Remove brake drums / disks (the Brake system see the Head).
- For size measurement люфтов in bearings it is required циферблатный a measuring instrument плунжерного type. Fix a measuring instrument at external edge of a flange ступичной assemblages.
- At check axial люфта плунжер a measuring instrument nestles to contacting to a brake drum / a disk of a surface of a nave (do not forget to null the device). For definition of size radial люфта, the measuring instrument fastens from nave lateral aspect, плунжером to its centre.
- Slowly rotating a nave, write down measuring instrument indications. Compare results of measurements to requirements of Specifications, in case of need make replacement ступичной assemblages (Removal and installation back ступичной assemblages see).
- In summary, estimate degree of a warp of an axis of the bearing, two wheel bolts tighten to a nave the metal lever. Establish the indicator on an external surface of a nave. Shaking a nave the lever, measure a bearing warp. If result of measurement it exceeds limiting admissible value (Specifications see), replace ступичную assemblage (Removal and installation back ступичной assemblages see).
- Remove a measuring instrument and establish to the place of a brake drum / a disk (the Brake system see the Head).
- Establish back wheels and lower the car on the earth. Tighten bolts of fastening of wheels with demanded effort.
|
|