Opel Astra
+ Cars Opel Astra and Zafira
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
Specifications
Removal and installation of a rotary fist
Check of a condition and replacement ступичной assemblages
Removal and installation of a forward stretcher
Removal, regenerative repair and installation of a rack of a forward suspension bracket
Removal and installation of the forward stabilizer of cross-section stability
Removal, regenerative repair and installation of the bottom lever of a forward suspension bracket
Replacement of the bottom spherical support
Removal and installation back ступичной assemblages
Check of a condition and replacement of bearings of back wheels
Removal, check of a condition and installation of the back shock-absorber
Removal and installation of screw springs of a back suspension bracket
Removal and installation torsion beams of a back suspension bracket
Replacement резинометаллических hinges of longitudinal levers torsion beams
System of adjustment of a road gleam of a back axis - the general information and adjustment
Removal and installation of the air valve and highway of a regulator of a road gleam of a back axis (model the Versatile person)
Removal and steering wheel installation
Removal and installation of a steering column
Removal, check of a condition and installation of an intermediate shaft of a steering column
Replacement of protective covers картера the steering mechanism
Removal and installation of the steering mechanism
Removal and installation of the steering pump
Removal of air from hydraulic path ГУР
Removal and installation of tips of steering draughts
Removal and installation of steering draught
Corners of installation of wheels
+ Body
+ Onboard electric equipment
|
Removal and installation of screw springs of a back suspension bracket
|
|
In view of design features of a suspension bracket back springs can be replaced only serially. Replacement of springs should be made in the complete set. |
Removal
|
|
- Prop up forward wheels противооткатными boots, поддомкратьте a back of the car and establish it on props. Remove back wheels.
- On the models the Versatile person equipped with system of adjustment of a back road gleam uncover the right back combined lantern in a luggage space and through the valve pit pressure from system. Disconnect from the shock-absorber an air tube.
- Prop up the corresponding longitudinal lever of a back beam тележечным a jack.
|
- Turn out the bottom bolt of fastening of the shock-absorber to the lever.
|
|
- Accurately wring out the longitudinal lever as far as possible downwards, without loading a brake line.
- Remove a spring and its rubber saddles from the longitudinal lever and кузовного an element and take components from under the car (the Design of a back suspension bracket see an illustration), - pay attention that the top saddle is equipped by the built in chipper.
|
|
Installation
Installation is made in an order, the return to an order of dismantle of components. Pay attention to following moments.
|
|
- Before shock-absorber installation make sure of correctness of installation of a spring and prorates.
- Track, that the shock-absorber fixture has been tightened with demanded effort.
- Do not forget that springs should vary in steam, - repeat procedure for the second spring.
- On the models equipped with system of adjustment of a back road gleam charge system air pressure 0.8 bar, then adjust pressure according to degree of loading of the car.
|
|
|
|