Opel Astra
+ Cars Opel Astra and Zafira
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
- Manual transmission
Specifications
Adjustment of a drive of a gear change
Removal and installation of the mechanism of a gear change
Replacement of epiploons
Check of serviceability of functioning, removal and installation of the gauge-switch of fires of a backing
Removal and installation of the gauge of speed (VSS)
Replacement трансмиссионного oils
Removal and installation manual transmission
Repair manual transmission - the general information
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Check of serviceability of functioning, removal and installation of the gauge-switch of fires of a backing
Check
A food to lamps of fires of a backing moves through the gauge-switch плунжерного the type, screwed in the top part картера manual transmission.
|
|
- At refusal of operation of fires, first of all check up integrity of a corresponding safety lock.
- Disconnect from the gauge-switch electroconducting. By means of an ohmmeter or a lamp-sampler make sure of serviceability of transition of the gauge-switch in the closed condition at a reverse gear choice. In case of need make gauge-switch replacement, - preliminary check up on presence of signs of breakage or short circuit corresponding electroconducting.
|
|
Removal
Models F13, F17 and F18
|
|
- For the purpose of maintenance of adequate access remove the storage battery with the adjusting pallet (the engine Electric equipment see the Head).
|
- Disconnect from the gauge-switch electroconducting, turn out it from картера manual transmission and remove in gathering with a sealing washer.
|
|
|
Model F23
|
|
- Cock a lay brake, поддомкратьте redock of the car and establish it on props, at a corresponding complete set remove protection картера.
|
- Disconnect from the gauge-switch (2) electroconducting (1), turn out it from картера manual transmission and remove in gathering with a sealing washer.
|
|
|
Installation
Models F17 and F18
|
|
- Having replaced a sealing washer, screw the gauge-switch in картер manual transmission and tighten with demanded effort. Connect electroconducting and, - if removed, - establish into place the storage battery. Check up serviceability of functioning of the gauge-switch.
|
|
Model F23
|
|
- Having replaced a sealing washer, screw the gauge-switch in картер manual transmission and tighten with demanded effort. Connect electroconducting, at a corresponding complete set establish protection картера, then lower the car on the earth.
|
|
|
|