|
Removal and installation of components of the uniform lock
The electronic block of management
|
|
In the block the gauge of blows is built in. At replacement the block should be programmed by means of the special equipment on a firm car repair shop of company Opel. |
|
|
The management block is established under a decorative overlay of a threshold of the right forward door. |
|
|
- Disconnect a negative wire from the battery.
- Remove a lateral decorative overlay of a threshold of the right forward door (Removal and installation of panels of internal furnish of salon see).
- Disunite two contact sockets of electroconducting.
|
- Give fixing nuts (are shown by arrows) and remove the block.
|
|
- Installation is made upside-down.
|
|
Activators of door-locks
Activators are built in in замковые assemblages, the description of procedures of removal and installation – see Removal and installation of door-locks.
Activators of the lock of a cover of luggage branch / of a door of a back
|
|
- Remove the decorative panel from the interior of a door of a back/cover of a luggage space.
- On models the Sedan uncover the lock cylinder.
|
- Release a plastic clamp and disconnect draught of management of the activator from the lock.
- Disconnect from the activator electroconducting.
- Turn out fixing screws and remove the activator from a door of a back / of a cover of a luggage space.
|
|
- Installation is made upside-down.
|
|
The activator of the lock of a door лючка a jellied mouth of a fuel tank (model the Sedan and Hetchbek)
|
|
- Remove a carpet covering a luggage space.
- Remove the back decorative panel (Removal and installation of panels of internal furnish of salon see).
- Disconnect from the activator electroconducting.
|
- Open a cover лючка a jellied mouth, turn out fixing screws (are shown by arrows).
|
|
- Cнимите the activator (1) with приводным an element (2).
|
|
- Installation is made upside-down.
|
|
The activator of the lock of a door лючка a jellied mouth of a fuel tank (model the Versatile person and Zafira)
|
|
- In a back part of a luggage space release plastic clamps and open an access cover to the activator.
|
|
- Disconnect from the activator electroconducting.
- Open a cover лючка a jellied mouth, turn out fixing screws and remove the activator.
- Installation is made upside-down.
|
|
|